Languages:  English  Traditional Chinese  
ARM Cortex Computing Platform

Product 1/2

Previous
Return to the Product List
Next

SBC-SMART-BEE

Highlight

  • TI Sitara AM335X @600MHz, 800Mhz or 1GHz
  • 512MB DDR3
  • 4GB eMMC Flash
  • 18-bit and 24-bit LVDS LCD
  • SDHC/SDIO
  • 10/100Mbps Ethernet x 2
  • COM x 3, USB 2.0 x 2
  • CANbus, I2C x 3, Stereo Audio, GPIO
  • Typical 2.5W

Possible Applications

  • HVAC Building and Control Systems
  • Fire Alarms
  • Smart Grid and Smart Metering
  • Home Gateway
  • HMI/ In-Home Display
  • Smart Toll Systems
  • Connected Vending Machines
  • Fiscal Printer/ Weighing Scales/ Currency Counter
  • Education
  • The Internet of Things (IOT)
  • Access Control


Quick Start Guide of SBC-SMART-BEE

These quick start guides are intended to provide developers with simple instructions on how to install SBC-SMART-BEE single board computer from very beginning and have it monitoring your local device in few minutes. No advanced installation options are discussed here - just the basics that will work for 95% of users who want to get started. This guide will lead you through the process of configuring, installing, and developing SBC-SMART-BEE. This guide was written to be as clear as possible and to provide only the details necessary to get you up and running. For more in-depth information, links to other chapters will be located where appropriate.
Step 1. Plug a working SD card into SD Slot (CN16)
An image pre-installed SD card comes with the evaluation kit. Plug the SD card into SD card slot (CN16). If developers do not have evaluation kit, please refer to Embedian Setup SD Card to prepare for a working SD card first.
plug your SD card in

Step 2. Check Jumper and Switched
SW1 switch should be set as SD boot (ON OFF OFF) and make sure that JP3 is not shunt.
boot strap selection switch

Step 3. Wired the console and Ethernet cable
Connect the DB9 to RJ-45 console debug cable from CN14 of the device to your PC and the Ethernet cable from LAN1 (CN4) of the device to an Ethernet switch. The default Ethernet configuration is dhcp.
Wire the Console and Ethernet Cables

Open a serial terminal like Putty in your PC. Set the COM port as 115200, 8n1.

Step 4. Power 5V to the device
Apply 5V to CN2 connector of the device. If you see the LED light on, that means the wiring is correct. Do not need to worry about the mis-wiring because the device has mis-wiring protection.
If your root filesystems is Arago. There is no password needed for root user. If your root filesystems is Ubuntu 13.04, the default root password is "root" (no quotation) and default Ubuntu user password is "temppwd".
Back
Your IP Address is: 3.17.6.75